Tuesday 17 May 2016

TAZ5 cabinet completed

Here is the finished cabinet.
Width: 650mm
Depth: 650mm
Height: 580mm



I have changed the spool holder idea, now the top rack is for storage only. I added another extrusion arm inside the cabinet, this uses the existing guide nice to another support strut, and means the printer can be used easily without the case.


Plenty of room on top of the cabinet for storage and laptop etc. The acrylic does bend a bit, so I may look into more internal support.


I'm going to leave the active cooling for now, and just see how warm the cabinet gets during printing. I have the parts ready to install, but this does make the build more complicated, and may not be necessary.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.